MIG Welding

MIG Welds Not Penetrating Enough? Here’s the Real Fix (Welder’s Guide)

Quick Answer:Your MIG welds aren’t penetrating because your voltage is too low, wire feed speed is too high, your travel […]

Quick Answer:Your MIG welder birdnests because the wire can’t feed smoothly. The most common causes are wrong drive-roll tension, incorrect

Your MIG welder keeps tripping the breaker because it’s drawing more amps than the circuit can handle, the breaker is

Quick Answer:The best MIG wire for automotive sheet metal is .023″ ER70S-6 solid wire with 75/25 argon-CO₂ gas. It gives

Quick Answer (Straight to the Point) You fix porosity in MIG welds by: Porosity happens when air gets into the

Quick Answer (Straight to the Point) For welding 1/4” steel with MIG, your best starting settings are: These settings get

Quick Answer (Straight to the Point) If your MIG weld is popping or crackling, it usually means your weld is